Magnetic probe array with high sensitivity for fluctuating field

A magnetic probe array is constructed to measure precisely the spatial structure of a small fluctuating field included in a strong confinement field that varies with time. To exclude the effect of the confinement field, the magnetic probes consisting of figure-eight-wound coils are prepared. The spatial structure of the fluctuating field is obtained from a Fourier analysis of the probe signal. It is found that the probe array is more sensitive to the fluctuating field with a high mode number than that with a low mode number. An experimental demonstration of the present method is attempted using a field-reversed configuration plasma, where the fluctuating field with 0.1% of the confinement field is successfully detected.     

Preparation of PLZT Ferroelectric Films by RF Sputtering on 200 mmφ Substrate

(Pb, La)(Zr, Ti) O 3 (PLZT) thin films were deposited on 200mm } Pt/Ti/SiO2/Si substrates by RF magnetron Sputtering using multichamber production system. The Pb content in PLZT films deposited at low temperature was measured by X-ray fluorescence spectroscopy (XRF), and ferroelectrics properties were measured. Good uniformities of Pb content and deposition rate were achieved on 200mm } substrate. For ferroelectrics properties, only small deference was observed between the center and the edge of 200mm } substrate.     

Enhanced Development of Azoxymethane-Induced Colonic Preneoplastic Lesions in Hypertensive Rats

Metabolic syndrome is associated with an increased risk of colorectal cancer. This study investigated the impact of hypertension, a component of metabolic syndrome, on azoxymethane (AOM)-induced colorectal carcinogenesis using SHRSP/Izm (SHRSP) non-diabetic/hypertensive rats and SHRSP.Z-Lepr^fa/IzmDmcr (SHRSP-ZF) diabetic/hypertensive rats. Male 6-week-old SHRSP, SHRSP-ZF, and control non-diabetic/normotensive Wister Kyoto/Izm (WKY) rats were given 2 weekly intraperitoneal injections of AOM (20 mg/kg body weight). Two weeks after the last injection of AOM, the SHRSP and SHRSP-ZF rats became hypertensive compared to the control WKY rats. Serum levels of angiotensin-II, the active product of the renin-angiotensin system, were elevated in both SHRSP and SHRSP-ZF rats, but only the SHRSP-ZF rats developed insulin resistance, dyslipidemia, and hyperleptinemia and exhibited an increase in adipose tissue. The development of AOM-induced colonic preneoplastic lesions and aberrant crypts foci, was significantly accelerated in both SHRSP and SHRSP-ZF hypertensive rats, compared to WKY normotensive rats. Furthermore, induction of oxidative stress and exacerbation of inflammation were observed in the colonic mucosa and systemically in SHRSP and SHRSP-ZF rats. Our findings suggest that hypertension plays a role in the early stage of colorectal carcinogenesis by inducing oxidative stress and chronic inflammation, which might be associated with activation of the renin-angiotensin system.     

Determination of benzimidazole anthelmintics in livestock foods by HPLC

A simple and rapid liquid chromatographic method was developed for the simultaneous determination of twelve benzimidazole anthelmintics in livestock foods using reversed-phase high-performance liquid chromatography with photodiode array detection (PDA). A sample was homogenized with acetonitrile and n-hexane, and centrifuged. The acetonitrile phase was isolated and evaporated. The residue was dissolved in 0.1 mol/L carbonate buffer solution (pH = 9.1), sonicated, and then subjected to clean-up on a Bond Elut LRC-C18 cartridge. The benzimidazole compounds were separated isocratically on a Capcell Pak C18 UG 120 (5 microns, 150 x 4.6 mm i.d.) column and detected by PDA at 295 and 313 nm. Mixtures of acetonitrile and 0.05 mol/L ammonium acetate in mixing ratios of (20:80) and (40:60) were used as the mobile phase, and the flow-rate was 1.0 mL/min at 40 degrees C. The mean recoveries (n = 3) from 0.1-0.5 microgram/g added samples were 72.6-97.2% with coefficients of variation of 0.3-8.5%. The detection limits were 0.01-0.05 microgram/g.     

Preparation and characterization of porous and electrically conducting carbon-clay composites

Porous and electrically conducting carbon-clay composites were prepared by firing mixtures of carbon powder (0 to 20 wt%) and clay minerals. They showed porosity of 50 to 65% and had high mechanical strength (compressive strength = 130 to 400 kg cm^–2) as well as high resistance against thermal oxidation in air. Their electrical conductivity, , increased with increasing carbon content levelling off at about 20 wt% of carbon content to give a value of about 2 S cm^–1. Formation of carbon chains is considered to be responsible for the electrical conduction in the composite, and a model to correlate the electrical conductivity with the carbon content has been proposed by modifying a model previously proposed by Scarisbrick.     

A novel gene delivery system in plants with calcium alginate micro-beads

We have produced micrometer-sized calcium alginate beads referred to as "bio-beads" that encapsulate plasmid DNA molecules carrying a reporter gene. In order to evaluate the efficiency of the bio-beads in mediating genetic transfection, protoplasts isolated from cultured tobacco cells (BY-2) were transfected with bio-beads containing a plasmid that carries the modified green fluorescent protein gene CaMV35S-sGFP. With the bio-beads treatment, approximately ten-fold higher GFP expression was observed after 24 h incubation compared to that with the conventional method using a naked plasmid solution. Transfection was up to 0.22% efficient. These results indicate that bio-beads have a possibility for efficient transformation in plants.     

Pattern modification of a neuronal network for individual-cell-based electrophysiological measurement using photothermal etching of an agarose architecture with a multielectrode array

A new type of individual-cell-based on-chip multielectrode array (MEA) cell-cultivation system with an agarose microchamber (AMC) array for topographical control of the network patterns of a living neuronal network has been developed. The advantages of this system are that it allows control of the cell positions and numbers for cultivation using AMCs, as well as easy and flexible control of the pattern of connections between the AMCs through photothermal etching where a portion of the agarose layer is melted with a 1480 nm infrared laser beam. With adequate laser power, narrow micrometer-order grooves (microchannels) can easily be fabricated that can be used to combine neighbouring AMCs to enable topographical control of the neural network pattern. Using this system, an individual-cell-based neural network pattern was formed of rat hippocampal cells within the AMC array without cells escaping from the electrode positions in the microchamber during an eight-day cultivation, and could record cell firing in response to 1.5 V, 500 kHz stimulation through an electrode. This demonstrated the potential of the on-chip AMCMEA cell cultivation system for long-term single-cell-based electrophysiological measurement of a neural network system.     

Reliability and mechanical durability tests of flexible OLED with ALD coating

To improve the reliability and mechanical durability of a flexible organic light‐emitting diode display, the entire flexible display is coated with an aluminum oxide film by atomic layer deposition (ALD). Because the step coverage of ALD is excellent, the AlO_x film was deposited not only on the front and back surfaces but also on the side surfaces of the display. A high‐temperature and high‐humidity preservation test, repetitive bending tests, and a pencil hardness test were conducted on the flexible display with ALD‐AlO_x coating. The display survived 500 h of a 65°C, 95% preservation test, endured a 100,000‐time repetitive bending test with a curvature radius of 4 mm, and was found to have a pencil hardness of 4H.     

Repeatedly foldable AMOLED display

In this study, a 5.9‐inch foldable active‐matrix organic light emitting diode (AMOLED) display was developed. A folding test was performed repeatedly. The display survived the folding test (100,000 folds) with a curvature radius of 2 mm. To protect an organic light emitting diode (OLED) against moisture, inorganic passivation layers are provided on the upper and lower sides of the flexible display. Using our transfer technology, high density passivation layers can be obtained. The measured water vapor transmission rate of the layer is 7 × 10^?6 g/m²?day or less, which improves OLED reliability. With these techniques, we have developed a book‐type display, which is repeatedly foldable like a book, and a tri‐fold display including a display area, which is foldable in three.